1989 | Porsche 911 Speedster 3.2

Manufaktur 911 Speedster 3.2 **

The base vehicle was purchased by us in 2022 with a mileage of 100,000 km and then revised.

The vehicle was delivered from the factory with the following options:

Exterior color: G1

Interior: part leather black

Carpet color code: 5FV

139 Seat heating on the left

197 Stronger battery

243 Shortened shifter

340 seat heating right

383 Sports seat on the left, height-adjustable

387 Sports seat right, height-adjustable

470 Omission of front and rear spoilers

491 turbo look

533 alarm system interval

975 trunk lining with velor carpet

As part of the revision, the following options were added or changes made:

Audio: Blaupunkt Bremen SQR 46 DAB with hands-free kit and new speakers Suspension:

Suspension tuning Manufaktur 964; Pirelli tires with N identification

Engine: Factory engine parts revision package I with metal catalytic converter

All our vehicles are revised according to defined standards.It starts with checking the incoming status of each vehicle.This test includes the following work steps:

Thorough cleaning outside and the interior

Visual inspection of the paint

Visual inspection of the body

Visual inspection of the interior

Functional test of all components such as air conditioning/heating, lighting control units, etc.test drive

Visual inspection of chassis / brakes / engine

The second step is dry ice blasting.

This includes:

Removal of all underbody panels

Dismantle, clean and store all dismantled panels

Drain engine, transmission oil, washing water and brake fluid

Underbody, front, rear and engine compartment dry ice blasting

After dry ice blasting, the scope of the restoration is determined:

Another visual inspection of the underbody for corrosion and damage

Determination of the scope of the body work

Testing of the chassis components

Checking of all lines (brake, fuel, oil, etc.)

Overhaul electronic components depending on defects Engine:

Manufactory 964 partial revision package

Pressure loss and visual inspection

Dismantle the engine down to the camshaft housings, clean all parts

Check wear parts such as clutch etc. and replace if necessary

Ancillary units such as starter, generator

Check and replace if necessary

Check ignition system and replace if necessary

Check attachments for function and replace if necessary

Check blasting of exhaust system and replace if necessary

Transmission:

Check for leaks after visual inspection

Check wear parts and replace if necessary

Measure vehicle (set height, wheel load, track, camber, etc.)

Test drive / checking all functions / quality check Demonstration for acceptance of the main inspection, if necessary, entry of individualizations

Before delivery handover inspection